User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
GLOSSARY
GLOSSARY-4 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
desktop Basic display screen of the PC UI.
DJDE Dynamic Job Descriptor Entry. Command within an input data
stream used to modify the printing environment dynamically.
dot Unit of measurement representing a fraction of an inch, for
example, 300 dots per inch (dpi). It may also be referred to as a
picture element (pixel) or spot.
dpi dots per inch. A measure of printer resolution.
dry ink Minute dry particles of resin and carbon black used to create
images. Dry ink can accept an electrical charge.
duplex printing Printing on both sides (front and back) of a page. See also
simplex printing.
E13B A font used in magnetic character recognition.
EBCDIC Extended Binary Coded Decimal Interchange Code. Coded
character set consisting of 8-bit coded characters. It can
accommodate 256 characters.
edgemarking Use of graphic objects, usually lines or boxes, that bleed off the
edge of the physical page. See also physical page.
elite Smallest size standard typewriter type: 12 characters per
horizontal inch. See also pica.
enabler Hardware devices or software packages that allow the printer to
perform in a specified manner.
End-of-Job Summary A tally of the number of sheets printed against the total number
of sheets expected.
Enhanced Sheet Tracking A full accounting on a report by report basis of every sheet fed
into the printer.
EOT end of tape.
Ethernet Xerox local area network (LAN) that allows data to be transmitted
by cable from one device to another, enabling it to share the
network.
FCB forms control buffer. Buffer for controlling the vertical format of
printed output.
FCG finishing configuration utility.