User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
SYSTEM OVERVIEW OF THE 4635 LASER PRINTING SYSTEM
Figure 1-10. Printer control console
1. Continue button. Press this button to resume printing.
2. Stop button. Press this button to stop printing.
3. Sample button. Press this button to cause a sample of the
current print job to be sent to the sample tray.
4. Brightness control thumbwheel. Use this thumbwheel to
adjust the brightness of the printer control console display.
5. Language icon. If two languages are available for your
printer control console, selecting this icon allows you to
choose the language for the printer control console
messages.
6. Clear button. Select this button to clear fault messages.
7. Printer icon. Select this icon to display the printer mimic.
(This is the default display on the printer control console.)
8. Fault List icon. Select this icon to display the Fault List
screen. Refer to the “Fault masking and the printer control
console” section of chapter 12, “Problem solving tasks,” for
additional information on this screen.
9. Tools icon. Select this icon to display call for service
information and to adjust display features of the printer
control console (for example, alarm loudness).
10. Guarded Tools icon. This icon is reserved for the service
representative and operators who have completed Advanced
Customer Training (ACT).
1-10 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE