User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
BAR CODE OPERATING PROCEDURES
Turning bar code on or off
The 4635 LPS bar code feature may be activated either:
• Through the Messages window of the PC UI
• Through the system controller terminal
Turning bar code on/off through
windows 1. Open Job Control Menu at the System UI.
2. Open Bar Code Reader Control Window.
3. Select On, Off, or Alignment.
If you select Off, you may specify the number of pages
through which the bar code feature is to be deactivated.
Figure 14-1. Bar Code window
Note: The Bar Code Reader Control Window is only available if
the system has the Bar Code Reader option installed.
Turning bar code on/off through
command line Enter the following command:
BAR [{OFF[,n]/ON/ALI}]
OFF Disables bar code processing. The job can still be run,
but no sequence verification will occur. Audit reports
will show all deliveries as being without sequence
numbers. The BAR OFF MODE continues until BAR ON
is entered.
n This is an optional command indicating that the BAR OFF
condition will only continue for n image sides, or until
output encounters the end of report, whichever occurs
first.
The value of n can be in the range of 1 to 65534.
ON Allows the resumption of bar code processing.
14-2 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE