User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
MICR OPERATING PROCEDURES
The 4635MX system is designed to meet ABA standards and ANSI
and ISO specifications for automatic check handling. It prints the
variable data and the MICR line at the same time.
MICR materials
Toner and developer Both the toner and the developer are designed to function on a
4635MX LPS and do not function satisfactorily in the 4635 or
4135 systems.
Fuser agent Use only fuser agent in a 4635MX system.
Turning MICR mode on or off
The 4635MX LPS may run in MICR or non-MICR mode. This
gives you control of the printer MICR state. You can perform the
mode selection by entering commands either:
• Through the Messages window of the PC UI
• Through the system controller terminal
Turning MICR on/off through
windows 1. Open Job Control Menu at the System UI.
2. Open MICR Mode Control Window.
3. Turn MICR on or off.
Figure 13-2. MICR mode control window
Note: The MICR mode control window is only available if the
system has the MICR option installed.
Turning MICR on/off through
command line Enter the following command:
MICR [ON/OFF]
13-2 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE