User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
SYSTEM OVERVIEW OF THE 4635 LASER PRINTING SYSTEM
1/4 inch cartridge tape drive
The 1/4 inch cartridge tape drive, also referred to as QIC (quarter
inch cartridge), is used for performing sysgen, disk save and
restore (DSR), and file loading/backup for online system
configuration. (Refer to the “1/4 inch cartridge tape drive
procedures” section of chapter 7 for instructions on loading and
unloading cartridge tapes.)
Printer components
The printer is the part of the LPS that processes the electronic
images and produces the printed report.
Figure 1-5. 4635 printer
1. Processor feeder trays
2. Inverter feeder/stacker module (containing inverter, high-
capacity feeder, and high-capacity stacker)
3. Feeder/stacker module (containing additional high-capacity
feeders and high-capacity stackers)
4. Purge tray
5. Attention light
6. Sample tray
7. Printer control console
1-4 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE