User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
STATUS AND PRINT TASKS
Select feeder trays
Use this task to override stock selections in the print job and
force printing of a job using a specific tray, cluster, or a feeding
device.
Select Feeder Trays task through
windows 1. Select the Feed Mode header button from the Printer Status
window to open the Feed Mode window.
Figure 9-4. Feed Mode window
MAIN
AUX
AUTO
1
2
3
4
5
6
7
Cluster...
Note: Options 5, 6, and 7 only appear if the system is
configured with these parts.
2. Select one of the following options:
• To use the clusters set up in the print job, select MAIN
from the Feed Mode window.
• To feed paper from the Aux cluster, select AUX from the
Feed Mode window.
• To feed paper from all trays, select AUTO from the Feed
Mode window.
• To feed paper using a specific cluster, select Cluster... to
open the cluster window, then select an option from the
displayed list.
• To feed paper from a specific tray, select the tray number
from the Feed Mode window.
• To feed paper from a bulk feeder, select 7 from the Feed
Mode window.
9-8 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE