User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
HIP PRINTING TASKS
RECEIVE The job is currently being received.
SENDING The job is currently being sent.
PENDING The job is waiting to be sent.
QUEUED The job is in OCS job queue waiting to be
processed.
ACTIVE The job is being processed by input and/or
output.
OQUEUED Input phase is complete and the job is
queued for printing.
PRINTING Input phase is complete and printing is in
progress.
TRUNCATED The transfer was ended before completion.
COMPLETED The job was completed normally.
STORED The file was stored in a permanent file
directory.
SENT The file was successfully sent to the host.
ABORTED The job was aborted by a HIP or OCS
ABORT command.
HOSTABORT The job was aborted by the host command.
REJECTED The transfer from the host to the OEM was
rejected.
CANCELLED The transfer was cancelled by a host restart.
STOREFILE The job is a file to be stored, not printed.
CONCATENATED The job is a concatenated job.
RETAINDATA The job's data is retained for HIP CHANGE.
HOLDJOB The job is retained due to HIP CHANGE.
PASSTHROUGH The job is a pass through job.
(XPF, only)
8-14 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE