User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
HIP PRINTING TASKS
Figure 8-7 shows the format of a normal display screen.
Figure 8-7. Example of HIP job status display
HOST:hst:linemode HIP:runmode FILEMODE:filemode
JID# HOST NAME RECEIVED STATUS JOB# TIME
nnnn host name hh:mm:ss status 000 hh:mm:ss
. . . . . .
. . . . . .
. . . . . .
HP1110 END OF JOB DISPLAY
In the display, the following fields appear:
hst Specifies one of the possible hosts (XNS or
XPF).
linemode Specifies the status of the host interface
(OFFLINE, ONLINE PEND, READY, RECEIVING,
SENDING, or SUSPENDED).
runmode Specifies the jobs run mode (STARTED,
STOPPED, DUMP, or CONCATENATED).
filemode Specifies the acceptable file types (ALL JOBS or
PRINT JOBS).
nnnn Specifies the internal job identification number
(JID) for HIP.
hostname Indicates the host name on the file label.
0000 Specifies the job number assigned by OCS
when the job is submitted for printing. It is
0000 for nonprint and pending jobs.
hh:mm:ss Specifies the time a job was received and
when its status was last changed.
status Specifies the current status of a job, which is
one of the following:
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE 8-13