User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
JOB CONTROL TASKS
Sample
Use this task to print a single page sample of the current job
being printed.
• The job may be running or suspended.
• The job must be at least three pages in length for you to be
able to sample it.
• The next available page is printed twice and the extra page is
sent to the sample tray.
To get a sample, you may also:
• Press the <SAMPLE> key on the keyboard.
• Press the Sample button on the printer control console.
• Open the I/O window, which gives you the sample option,
by chording the mouse—that is, pressing both the left and
right buttons of the mouse at the same time. (Refer to figure
5-12.)
Note: A print job must be in output processing in order to
obtain a sample print. Also, you may not print samples when the
sample tray is the output destination for a job, for example,
when printing transparencies or when ordered stock is being
used in the job.
Sample task through windows Select “Sample” from the Job Control menu.
Sample task through command line To print a sample of the current print job, enter the following
command:
SAMPLE
5-18 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE