User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
JOB CONTROL TASKS
• To display the current image darkness value, enter the
following command:
DARKNESS
Lead edge screen
Use this task to apply a screen to the leading margin of a printed
sheet. The screen lightens a high density image in the margin.
The edge lightening change is applied to:
• The next print job
• The current print job if printing was interrupted.
Note: For MICR users, turn off MICR mode when adjusting the
EDGE settings.
If you select this task while the LPS is printing, the following
confirmation window appears on the PC UI.
Figure 5-7. Confirmation window (“Lead Edge Screen”
option)
• Select Yes to continue with the Lead Edge Screen task.
• Select No to cancel the task.
If you have the system controller terminal rather than the PC UI,
the following messages appears on the screen:
OS1331 LEAD EDGE SCREEN SETTING IS [OFF, NORMAL, STRESS]
OS0500 OUTPUT STOPPED
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE 5-9