User guide

Basic XNIC Commands
3-54 ❖ XNIC-ENET/TRING Configuration Guide
 CHANGE is a combination of SET and DEFINE. It
immediately changes a parameter and permanently
updates it in the NVRAM as well. Reinitializing the XNIC
is not needed for the changes to take effect. The syntax is:
change parameter value
 HELP displays instructions on the use of the various
commands. The syntax is:
help commandname
In XNIC, Version 5.x, the Help command is not available.
Refer to the table which begins on the next page for
information about the commands.
ETR-CH03 Page 54 Wednesday, October 23, 1996 6:46 PM