User guide

Basic XNIC Commands
Chapter 3: Using the Printer with Novell NetWare ❖ 3-53
Basic XNIC
Commands
The basic XNIC commands are as follows:
 SHOW displays the XNICs current information. Display
screens vary according to the specific SHOW parameter.
The syntax is:
show parameter
 MONITOR is the same as SHOW, except that the display
screen is updated every 10 seconds (every 1 second in
privileged mode). Press any key to exit the display. The
syntax is:
monitor parameter
 LIST displays the XNICs NVRAM (non-volatile RAM)
parameter settings. Display screens vary according to the
specific LIST parameter. The syntax is:
list parameter
 SET temporarily changes a parameter to a given value.
The change is valid until you log out from the XNIC or
turn OFF the printer. The syntax is:
set parameter value
 DEFINE permanently changes an NVRAM parameter to
a given value. You must reinitialize the XNIC for the
changes to take place. Use one of the following methods
to reinitialize the XNIC:
 Use the Reset All, Reset Ethernet command (for
XNIC-ENET), or Reset Token Ring command (for
XNIC-TRING) on the printer control panel.
(DocuPrint 4517 printer only)
 Power off the printer and then turn it back on.
 Issue an init delay 0 command remotely.
The syntax is:
define parameter value
ETR-CH03 Page 53 Wednesday, October 23, 1996 6:46 PM