User guide

Setting Optional Configurations

Chapter 3: Using the Printer with Novell NetWare ❖ 3-51

This procedure installs the TES/Kermit software on your

Novell workstation and establishes a connection with the

XNIC.

Insert the Utilities for: LAN Server, LAN Manager, Novell

NetWare (TES) diskette into your floppy disk drive and enter

the following command to install the files from the floppy

diskette in drive A: to hard drive C on your system:

a:\tes\ install a:\tes c:

Run TES by entering:

cd c:\tes-krmt

tes

To display information about TES commands, at the

DOS prompt, enter: tes help

Run Kermit by entering:

kermit

The MS-Kermit> prompt will appear.

You can optionally enter the following command to view a

listing of the XNIC cards on the network:

tes names

For example, you will see:

XNEx

xxxxx

for XNIC-ENET or

XNTxxxxxx for XNIC-TRING, where xxxxxx is the last six

characters of the XNIC address.

Specify which XNIC to use. Enter:

set port tes XNExxxxxx (for XNIC-ENET)

set port tes XNTxxxxxx (for XNIC-TRING)

For example:

set port tes XNE1076E3

ETR-CH03 Page 51 Wednesday, October 23, 1996 6:46 PM