User guide

Using the Printer with Novell NetWare
3-12 ❖ XNIC-ENET/TRING Configuration Guide
Restarting the
XNIC
After you complete the setup in PConsole, the XNIC needs to
be restarted so it can read the new configuration in the
NetWare file server. Power the printer off and power it on to
restart the XNIC.
The following procedure is an alternative method to restart
the XNIC.
1
Select Print Server Information from the Available
Options menu.
2
Select your XNIC Print Server name.
3
Select Print Server Status and Control.
This option appears only if the XNIC is powered on and
connected to the network and the configuration was
successful. Refer to the note on page 3-11 if your
network has more than 25 file servers.
If there is no response, check the network connection of
the printer and verify that the configuration of the print
server and queues on the file server is correct.
4
Select Server Info.
5
Select the Current Server Status field.
6
Select Going Down after Current Jobs.
ETR-CH03 Page 12 Wednesday, October 23, 1996 6:46 PM