User guide

Subnetting Example
A-2 ❖ XNIC-ENET/TRING Configuration Guide
A routing information table must be set up on the XNIC card
so that the printer will know the address of the router it must
go through to communicate with the workstation. Until this
communication link is working, Telnet will not work. Two
solutions are possible:
Solution 1: Put the printer on the same network as the UNIX
workstation, and use Telnet to install the printer.
Solution 2: Log into the XNIC following Step 1 on page 5-35
through Step 5 on page 5-36, then at the Local> prompt, enter
the following commands:
define server ip 129.9.62.96
define server subnet 255.255.255.224
define node ip 129.9.62.97 gateway default
sync
init delay 0
The XNIC will automatically reboot and the printer will then
be ready for use.
ETR-APPA Page 2 Thursday, October 24, 1996 7:21 AM