User guide

Troubleshooting
Chapter 11: Troubleshooting ❖ 11-19
LAT Problems
If you are printing from a LAT host, ensure that the queue
was set up and is running.
If the printer will not print, the XNICs name has been
changed. Follow these steps to correct the problem:
1
Connect to the card using the instructions in the section
Logging into the XNIC-ENET (page 6-5)
2
Issue the command: show server lat
Verify the name is the same as the node name you set up in
the section Configuring an OpenVMS LAT Host for LATSYM
(page 6-3).
3
Issue this command only if your XNIC is Version 4.x:
show port 1
4
Verify that the port name is PORT_1.
Note that the port name must end in an _1. If the port name
is incorrect, then rename the port. The command is:
change port 1 name new_name .
5
If either of these items is different than those defined in the
section Configuring an OpenVMS LAT Host for LATSYM
(page 6-3), then repeat the step using this new XNIC name.
ETR-CH11 Page 19 Thursday, October 24, 1996 7:14 AM