User guide

UNIX TCP/IP Problems
Chapter 11: Troubleshooting ❖ 11-15
 Check the error log(s) in the /tmp directory for possible
problems. If errors are not reported or if the error log
does not exist, verify the printer status using the lpc
(BSD) or lpstat -t commands (System V).
 Examine the /etc/printcap file for the xrx_text entry
and change disable to enable.
 Log into the XNIC and verify that the print definitions are
enabled for the protocol you are using. Also verify that
the service you are trying to use is authorized for the
desired protocol. Authorized protocols for the server are
displayed using the SHOW SERVER NETWORK
command. These commands are discussed in the section
Basic XNIC Commands (page 5-37).
 If you experience difficulties locating the problem on
TCP/IP networks, use the Log File or Trace Mode options.
ETR-CH11 Page 15 Thursday, October 24, 1996 7:14 AM