User guide

Basic XNIC Commands
Chapter 8: Using the Printer with LAN Server ❖ 8-27
Reset the XNIC remotely (soft reset).
init delay 0
Reset the XNIC to factory defaults.
init delay 0 default
Display NetBIOS characteristics.
show server netbios
Display network configuration parameters.
show server TCP
Create a new remote printer service.
change service name tcp_port priority nn
(where name is the new service name, tcp_port is a value
between 3000 and 5000, and nn is a value of 0 to 15, with 15
being the highest)
Default services all have a priority of 0 (lowest priority). All files
sent to a new service set with a higher priority take priority over
files sent to the default services.
Quotation marks around the service name are required when
using upper and lower case characters in the name.
Define the printers IP address.
define server ip ddd.ddd.ddd.ddd
(where ddd.ddd.ddd.ddd is the IP address of the printer)
Redefine the subnet mask.
define server subnet mmm.mmm.mmm.mmm
(where mmm.mmm.mmm.mmm is the subnet mask for the
network)
Define gateway address.
define node ip ggg.ggg.ggg.ggg gateway default
(where ggg.ggg.ggg.ggg is the address of the default router for
the printers network segment)
Table 8.2 XNIC tasks and commands (continued)
Task Command
ETR-CH08 Page 27 Wednesday, October 23, 1996 9:46 PM