User guide

Basic XNIC Commands
Chapter 8: Using the Printer with LAN Server ❖ 8-25
 CHANGE is a combination of SET and DEFINE. It
immediately changes a parameter and permanently
updates it in the NVRAM as well. Reinitializing the XNIC
is not necessary for the changes to take place.The syntax
is:
change parameter value
 HELP displays instructions on the use of the various
commands. The syntax is:
help commandname
In XNIC, Version 5.x, the Help command is not available.
Refer to the table which begins on the next page for
information about commands.
ETR-CH08 Page 25 Wednesday, October 23, 1996 9:46 PM