User guide

Connecting XNIC-ENET to the Network
2-4 ❖ XNIC-ENETT/TRING Configuration Guide
Thinnet (10base2)
Connection
1
If you are patching into the middle of the
cable, use a BNC T-adapter to connect to
the Ethernet cable.
2
If you are connecting to the end of a cable
segment, connect the Ethernet cable to
one side of the BNC T-adapter and
connect a 50 Ohm Ethernet terminator to
the other side.
3
Attach the BNC T-adapter to the BNC
port on the XNIC-ENET.
Do not attach anything to the port
marked UTP.
Etr-ch02 Page 4 Thursday, October 24, 1996 4:49 PM