User guide

Basic XNIC-ENET Commands
Chapter 6: Using the Printer with LAT on XNIC-ENET Only ❖ 6-9
Table 6.1 lists the most useful XNIC-ENET commands,
organized by network environment and task.
Table 6.1 XNIC-ENET tasks and commands
Task Command
Display information about the XNIC-ENET
characteristics and the specific options
that are enabled.
show server characteristics
Each parameter displayed may be altered using the appropriate
SET/CHANGE/DEFINE command.
If you have a VT100-compatible terminal, the show server
characteristics command displays a stack of overlapping
screens which can be cycled for display with the arrow keys.
Display revision levels and the self-test
results.
show server hardware
Display Document Services for Printing
(DS/P) parameters (refer to the Document
Services for Printing Guide).
show server dsp
Display the overall server configuration
and start-up parameter setting.
show server local
This command is disabled on the XNIC-ENET if DS/P is enabled.
Print a Network Configuration Sheet for
Ethernet.
show config port 1
This command is disabled on the XNIC if DS/P is enabled.
Display the overall network configuration,
including the Ethernet hardware address
and the protocols currently supported.
show server network
Change the login password from the
default of access at the prompt
showing #.
define server login password password_1
(where password_1 is the new login password)
Change the privileged password from the
default of system at the prompt
showing password>.
define server privilege password password_2
(where password_2 is the new privileged password).
Disable protocols on the XNIC-ENET.
define server authorize protocol disabled
(where protocol is one of the following: NetWare, AppleTalk,
TCP/IP, LAT, NetBIOS, All, or None.)
Enable protocols on the XNIC-ENET.
define server authorize protocol enabled
(where protocol is one of the following: NetWare, AppleTalk,
TCP/IP, LAT, NetBIOS, All, or None.)
ETR-CH06 Page 9 Wednesday, October 23, 1996 9:24 PM