User guide

Basic XNIC-ENET Commands
Chapter 6: Using the Printer with LAT on XNIC-ENET Only ❖ 6-7
Basic
XNIC-ENET
Commands
The basic XNIC-ENET commands are as follows:
 SHOW displays the XNIC-ENETs current information.
Display screens vary according to the specific SHOW
parameter. The syntax is:
show parameter
 MONITOR is the same as SHOW, except that the display
screen is updated every 10 seconds (every 1 second in
privileged mode). Press any key to exit the display. The
syntax is:
monitor parameter
 LIST displays the XNIC-ENETs NVRAM (non-volatile
RAM) parameter settings. Display screens vary according
to the specific LIST parameter. The syntax is:
list parameter
 SET temporarily changes a parameter to a given value.
The change is valid until you log out from the
XNIC-ENET or turn OFF the printer. The syntax is:
set parameter value
 DEFINE permanently changes an NVRAM parameter to
a given value. You must reinitialize the XNIC-ENET for
the changes to take place:
 Use the Reset All or Reset Ethernet command on the
printer control panel (DocuPrint 4517 printer only).
 Power off the printer and then turn it back on.
 Issue an init delay 0 command remotely.
The syntax is:
define parameter value
 CHANGE is a combination of SET and DEFINE; it
immediately changes a parameter and permanently
updates it in the NVRAM as well. The syntax is:
change parameter value
ETR-CH06 Page 7 Wednesday, October 23, 1996 9:24 PM