User guide

Using the Printer with LAT on XNIC-ENET Only
Chapter 6: Using the Printer with LAT on XNIC-ENET Only ❖ 6-5
Setting
Optional
Configurations
This section describes optional procedures for communicating
with the XNIC-ENET to monitor system parameters or to
change the parameters from their factory defaults.
Logging into the
XNIC-ENET
To monitor or change configuration parameters on the
XNIC-ENET, you must first log into the XNIC-ENET from
your host.
Use the following procedure to log into the XNIC-ENET from
your host:
1
Run the NCP utility on the VAX by entering:
run sys$system:NCP (or mcr ncp)
2
Connect to the XNIC-ENET RCF port by entering:
connect via qna-0 physic addr
nn-nn-nn-nn-nn-nn
where qna-0 is your actual circuit type, and
nn-nn-nn-nn-nn-nn is the XNIC-ENETs Ethernet hardware
address.
3
At the # prompt, enter the password.
The default is access. You will not see what you enter.
4
Enter your user name if the following prompt is displayed:
Enter username or HELP>
(Any name is acceptable as a user name.)
5
At the Local> prompt, enter su
ETR-CH06 Page 5 Wednesday, October 23, 1996 9:24 PM