User guide

Configuring an OpenVMS LAT Host for LATSYM
6-4 ❖ XNIC-ENET/TRING Configuration Guide
3
To set up the terminal parameters, at the $ prompt enter the
following sequence of commands:
set terminal ltannn : /perm -
/device=la36 /width=80 /page=66 -
/lowercase /nobroadcast
set protection=(s:rwlp,o,g,w:rwlp) -
/device ltannn :
set device ltannn :-
/spooled=( queue_name , -
sys$sysdevice:)
where queue_name is defined by you or the system
administrator.
4
To initialize the printer queue, at the $ prompt enter the
following command:
initialize /queue /start -
/processor=latsym -
/retain=error -
/on= ltannn : -
/default=(noburst, flag=one, -
notrailer) -
/record_blocking -
queue_name
5
Print a file.
For example:
print /queue= queue_name file_name.ext
If you do not use /noflag in the print command, a
banner page will print at a width of 132 characters.
ETR-CH06 Page 4 Wednesday, October 23, 1996 9:24 PM