User guide

Basic XNIC Commands
5-38 ❖ XNIC-ENET/TRING Configuration Guide
 CHANGE is a combination of SET and DEFINE; it
immediately changes a parameter and permanently updates
it in the NVRAM as well. The syntax is:
change parameter value
 HELP displays instructions on the use of the various
commands. The syntax is:
help commandname
In XNIC, Version 5.x, the Help command is not available.
Refer to the table which begins on the next page for information
about commands.
Etr-ch05 Page 38 Thursday, October 24, 1996 7:31 PM