User guide

Using the Printer with UNIX TCP/IP
Chapter 5: Using the Printer with UNIX TCP/IP ❖ 5-37
Basic XNIC
Commands
The basic XNIC commands are as follows:
 SHOW displays the XNICs current information. Display
screens vary according to the specific SHOW parameter. The
syntax is:
show parameter
 MONITOR is the same as SHOW, except that the display
screen is updated every 10 seconds (every 1 second in
privileged mode). Press any key to exit the display. The
syntax is:
monitor parameter
 LIST displays the XNICs NVRAM (non-volatile RAM)
parameter settings. Display screens vary according to the
specific LIST parameter. The syntax is:
list parameter
 SET temporarily changes a parameter to a given value. The
change is valid until you log out from the XNIC or turn OFF
the printer. The syntax is:
set parameter value
 DEFINE permanently changes an NVRAM parameter to a
given value. Use one of the following methods to reinitialize
the XNIC:
 Use the Reset All, Reset Ethernet command (for
XNIC-ENET), or Reset Token Ring command (for
XNIC-TRING) on the printer control panel (DocuPrint
4517 printer only).
 Power off the printer and then turn it back on.
 Issue an init delay 0 command remotely.
The syntax is:
define parameter value
Etr-ch05 Page 37 Thursday, October 24, 1996 7:31 PM