User guide

Manual Installation Procedure
5-26 ❖ XNIC-ENET/TRING Configuration Guide
9
Define routing tables in the XNIC card if the printer needs to
know the address of routers in the network. Otherwise skip
to the next step.
Enter:
define node ip ggg.ggg.ggg.ggg gateway
default
(where ggg.ggg.ggg.ggg is the address of the default
router for the printers network segment).
10
To enable the parameters set above, reset the XNIC by
entering:
init delay 0
11
Log out of the XNIC by entering:
logout
12
Update the file /etc/hosts (or /usr/etc/hosts) on your UNIX
system by adding a line describing the XNIC as follows:
ddd.ddd.ddd.ddd server_node_name
where ddd.ddd.ddd.ddd is the new IP address you
assigned in Step 7.
For example, if the IP address is 138.239.111.111, enter:
138.239.111.111 XNE xxxxxx
Caution
After you change an existing IP address, be sure to write
down the new IP address. You will need it in order to locate
the printer on the network.
Etr-ch05 Page 26 Thursday, October 24, 1996 7:31 PM