User guide

Manual Installation Procedure
5-18 ❖ XNIC-ENET/TRING Configuration Guide
Verifying BootP Operation on the XNIC
Next you will need to configure the print queue, using one of the
following three options:
 Print Queue Option 1: Setting up lpd (page 5-27)
 Print Queue Option 2: Setting up RPRINT on BSD Hosts
(page 5-30)
 Print Queue Option 3: Setting up RPRINT on System V
Hosts (page 5-32).
1
Power on the printer so that it can send a BootP request on
the network.
2
Verify that the XNIC received the IP address by entering
arp -a
on the UNIX machine.
This will show you the entries made into the ARP Static Table.
3
You can also verify that the printer received the IP address
by printing out a Printer Configuration Sheet. Refer to
page 1-11 for instructions on printing the configuration
sheet.
Etr-ch05 Page 18 Thursday, October 24, 1996 7:31 PM