Instruction Manual

The Remote Control Panel (RCP)
Chapter 5: Using Software Tools ❖ 5-7
the other interface. The default value is 20 seconds.
Active only when optional serial interface is installed.
• Auto Continue
It determines the printer action when the user prints a
page without paper in the manual feed slot but the paper
source is set to manual feed. If Auto Continue is ON, the
printer picks up the paper from the tray after ten seconds.
If Auto Continue is OFF, the printer waits until the user
inserts paper into the manual feed slot.
• Baud Rate
Sets the speed of the serial interface. The default value is
9600 BPS.
• Robust XON
If it is ON, the printer sends XON character every one
second. The default value is ON.
4508-c05.frm Page 7 Wednesday, May 22, 1996 7:09 AM