User Guide

English

Xerox WorkCentre 3550

Quick Use Guide

Networked Printer

When you connect your printer to a network, you must first configure the

TCP/IP settings for the printer. After you have assigned and verified the TCP/IP

settings, you are ready to install the software on each computer on the

network.

1. Make sure that the printer is connected to your network and powered on.

For details about connecting to the network, refer to Connecting to the

Network on page 13.

2. Insert the supplied CD-ROM into your CD-

ROM drive. The CD-ROM should

automatically run, and an installation

window appears.

• If the installation window does not

appear, click Start and then Run. Type

X:\Setup.exe, replacing “X” with the

letter which represents your CD drive

and click OK.

• If you use Windows Vista, click Start > All programs > Accessories >

Run, and type X:\Setup.exe. If the AutoPlay window appears in

Windows Vista, click Run Setup.exe in Install or run program field,

and click Continue in the User Account Control window.

3. Click Install Software.

4. Click Typical installation for a network

printer and follow the wizard instruction to

select and install the printer.

Note: For Custom install instructions, refer

to the System Administrator Guide.

5. After the installation is finished, click

Finish.

If the Test Print operation is successful, continue

on to the next setup procedure in this document.

If the print operation failed, refer to

Troubleshooting on page 35.