Electronic Documentation Laser 3270 Programmer's Guide
Table Of Contents
- Front Page
- Approvals/Warnings
- Preface
- Important Note
- Related Manuals:
- Table of Contents
- 1. Introduction
- 2. Function Selection via the Line
- 3. Manipulation of Temporary and Permanent Memory Areas
- 4. IBM 3270 Related Functions -Special Settings
- 5. Serial Input
- 6. Printer Sharing
- 7. Printer Initialization by User Strings
- RS 232/V24 Cable Connection (serial support) - Appendix A
- List of Abbreviations - Appendix B
- Index
3270 Programmer’s Guide
Introduction
- 8 -
• Full IBM 3268/87 and 4214 emulations including the APL feature
and all applicable RPQs (subject to restrictions of the ASCII
printers).
• Serial input or output (in case of serial connector)
• Access to all the special facilities on your Xerox printer from the
host.
• Automatic input sharing between Coax, Centronics and RS (in
case of serial connector) input.
• Coax FSL setup via Centronics.
• Support of up to 8 user strings of variable length can be transmit-
ted to the printer from the converter - automatically at power on
and before and after Local Copy from the host system.
• Up to 16 translate tables (8 for text and 8 for APL) which may be
modified as you wish. Each character from the host may be
transmitted to up to 12 ASCII characters.
• Flash PROM allowing the downloading of new firmware via the
coax or the Centronics port.
• Full backwards compatibility with existing products.
• Support of ida PSS software package
1.5. 3270 Protocol Converter Programming
The 3270 Protocol Converter uses a large number of internal setup
functions. See Chapter 2. Function Selection via the Line. When the
converter is installed and connected to a printer, you may have to
consider the use of these settings.
NOTE: (If running in FSL mode)'
The converter should be programmed to make your
decentralized printer as fully 3268/3287 compatible as
possible. This is particularly important in an SNA/LU1
environment.