User guide

30
S ETTINGS
Select CHANGE CODE using  or . Press
Valid. .
Enter the old base code using the keypad
(default is 0000). Press Valid. .
Enter the new base code using the keypad.
Press Valid. .
Confirm by entering the new base code
again. Press Valid. .
To exit the menu, press the red key .
Carefully note down the base code
number. You will need this code to
change certain settings.
H ANDSET SETTINGS
Registering a new handset to a
terminal
To register a new handset to a base you
must:
• put the handset in registration mode,
• put the base in registration mode.
Once this is done, the registration (mutual
recognition of the base and the new handset)
will be done automatically (registration can
take a few seconds).
Take the handset to be registered:
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET HANDSET using  or . Press
Valid. .
Select REGISTRATION. Press Valid. .
Press Yes to put the handset in
registration mode.
The handset enters the registration mode.