Document Centre Setup Guide

Xerox Document Centre 220/230/332/340 Setup Guide Page 2-5
About Setups
About Setups
Changing the Settings
Switch On
To switch ON the power to the Document Centre
220/230/332/340 press the Power ON/OFF button which is
located on the upper-right side, near the front of the
machine. It takes approximately 3 minutes for the machine
to warm up and perform a self-test.
CAUTION
To avoid damage to the machine after switching OFF,
allow at least 10 seconds before switching the power
ON again.
The first time the machine is switched ON, a message is
displayed. Follow the instructions in the pop-up window to
enable the machine to synchronize its components. This
message will not be displayed again.
Access the Setup Tools
When the Document Centre 220/230/332/340 is delivered, it
contains a default password (#22222) which can be used to
provide access to the Setup Tools prior to PINs and Access
Rights being assigned.
To change the default password refer to “Access Rights” on
Page 7-1.