User's Manual

Jamming with
lightweight
papers
Lightweight papers can cause degraded performance (jam rate to stacking
performance). Hint...Check for excessive paper curl, adjust decurler as
needed. Other recommendations include:
Check ↓↑ orientation in feeder loading (flip stack).
Run in rotated mode.
Avoid < 60 GSM (16#).
Use good quality paper.
PCL job with job
separator
command
27837
To print and finish a job that contains the PCL job separator command
(&l1T), send the job to a queue that does not have an override set for
finishing. A default value is okay - just make sure there is no override.
Setting an override for Finishing results in all job level finishing options
being ignored and the default finishing option being applied to the full job.
The PCL job separation command falls into finishing category.
MFF (for both Professional and Pro Plus)
Subtopic CQ# Description and Recommended Action
Finisher Unload
Button
10402 You do not need to press the Finisher Unload Button to remove output from
the finisher. When you press the Finisher Unload Button, the finisher cycles
down. Press the Finisher Unload Button again to re-enable marking.
C or Z fold jobs
rotated 180
degrees
19879 If landscape C-fold or Z-fold jobs printed from print clients, or the SDDF
LEF scan, are rotated 180 degrees, select 180 degree rotation from the
Advanced tab in Print Drivers at the PC application or from the Image Edit
tab, Image Rotation, at the Copier/Printer user interface.
PostScript Jog
command
24772 The PostScript Jog command, when used within a job, does not perform as
described in the Adobe PostScript specifications. Changes to the Jog value
create subsets to which the job or queue level finishing selections are
applied. For example, if a job specifies<</Jog 3>> setpagedevice on page 1
and <</Jog 0>>setpagedevice on page 5, then pages 1 through 4 will be
finished as a unit and pages 5 through the end of the job will be finished as
a separate unit. This is the same behavior as other Xerox production
printers, such as the DocuTech 6180.
MFF Pro Plus
Subtopic CQ# Description and Recommended Action
Free Flow Print
Manager (FFPM)
40370 Free Flow Print Manager does not provide a method to combine staple and
hole punch for a job. As a work around, hold the jobs and update your
finishing selection using “Multiple Finishing”.
Punching heavy
weight paper
40269 If you do not have the Productivity Pack license and you are hole punching
Heavy weight paper, do not run paper greater than 200 gsm. This is a
documented machine limitation.
Hole Punching
with mixed sizes
41192 If you are using Copy Services and are hole punching a job with paper
sizes of both LEF and SEF, the pages will print and hole punch correctly.
However, if you save the job and reprint it later, the job will fault since the
Print Services cannot currently hole punch mixed sizes.
2/3 and 2/4
Punch dies
39409 If you have a MFF with hole punch and both the 2/3 and 2/4 hole punch
dies, any job programmed for 2 hole punch will punch with either die
loaded. Be sure the appropriate hole punch die is loaded before submitting
the job. On a 2/4 hole punch, the two center holes are 80 mm apart. On a
2/3 hole punch, the two center holes are 70 mm apart.
26