User's Manual

Staple print with
two stock sizes
20726 If you want to staple print a job that requires two sizes of SEF stocks, and
one of them is also loaded LEF, program both the stocks that you want to
use with the same custom Type. When sending the job, select the custom
Type and the job will use the correct paper and staple. If you do not do this,
the job will fault because it will attempt to use LEF paper and won't be able
to staple.
Tab job –
landscape with
tabs at top
22918 When submitting a landscape job that contains tabs running across the top,
enable the 180 rotate option to get the proper orientation of the image on
the tabs.
Tab job with
drilled paper
(MFF configs.
only)
18504 For MFF configurations only: When running a tab job with pre-drilled paper
for the main body pages, the pre-drilled paper must be loaded with the
holes leading, which is opposite of what the label on the tray indicates.
Tabs in a “Print
and Save” Build
Job
27381 For a ‘Print and Save’ Build Job, when scanning tabs on the platen, scan
the tabs with the tab leading and use a Manual Original size of 9x11. If you
do not do this, the images on the tabs will be upside down when reprinted.
When paper runs
out, do not restart
or shut down
35440 When printing a job, if it runs out of paper, do not restart/shutdown the
machine. If you do, the job may resume on the wrong orientation paper.
Example: If your job was printing on Letter LEF and ran out, the system
was restarted, the job may resume printing on Letter SEF. As a work
around, disable any trays of the wrong orientation before the
restart/shutdown or fill the correct tray before the restart/power up
completes.
Imposition
Subtopic CQ# Description and Recommended Action
Job Forwarding 30531 When forwarding jobs that contain Imposition/Annotation programming, the
Imposition/Annotation programming will not be forwarded with the job.
No support for
PDF annotation
34780 DocuSP Imposition does not support PDF annotations. The job will print
without the annotation after the imposition is applied.
Queue for
imposition
11189
DocuSP supports automatic creation of Signature Booklets and other multi-
up imposition formats. This can be done from any Print job in the active or
inactive job list or from the Print from File pathway. This is supported for
jobs submitted from print drivers and from print ready print submission tools
such as FFPM and the WebUI. Suggested workflow for creating such jobs
is to do one of the following:
1. Hold the job and reprogram it to perform the desired imposition.
2. Setup a queue with the default Layout set to the desired imposition.
Submit the job directly to that queue and the imposition will be
applied to the job.
17