User's Manual

Fault 10-2725 A 10-2725 fault (indicating that the fuser stripper fingers failed to

home) may occur after a system restart. Clearing the fault should

permit normal machine operation.

Finisher paper sizes 08993,

9270

Paper sizes currently supported by the finisher are stated on page 24

of this document.

Fonts 34864 After adding/deleting fonts, DocuSP must be restarted before the

fonts are successfully added/deleted.

Job forwarding 30530 If you forward a job from one machine to another, the forwarded jobs

will lose their Printer Darkness setting.

Job recovery 26395 After an uncontrolled system reboot (e.g. power outage/tripped

breaker, kernel panic, or power cycle using the white button), job

recovery does not always work correctly. In those cases, the

recommended procedure is to open the job properties and set the

Pages to Print values to the range of pages remaining to be marked.

Licensing 34005 Do not Deactivate an entire license package to disable one feature

(such as AppleTalk in the Ethernet package). The individual features

of license packages can be enabled or disabled by right clicking on

the feature line, selecting Properties, then selecting Enable or

Disable.

Restart 27197 If the system is restarted during printing of a very long job, the

system may take a long time to recover the job -- approximately 1

minute for each 10,000 pages in the job.

Solaris Solaris 10 has retired several popular GUI applications commonly

used by support personnel. Admintool, commonly used to add hosts,

users, printers, and other administrative tasks has been replaced by

a new more powerful System Administration utility called Solaris

Management Console, or smc and a separate Printer Manager, or

printmgr. Dtpad is the new GUI text editor that has replaced textedit.

All other command line utilities used to perform common

administrative tasks are still available.

Note: Solaris Management Console is only available with

Security setting set to None.

Subset programming 26871 Subset offset and finishing can be programmed in the Job manager

or on a Queue. This works fine for simplex jobs. It will also work for

duplex jobs, as long as the request is for an even number of images.

But if the request is for a subset that would require a duplex page to

be split, then the request will fail.

CD Media Selection

CD-R media Use only high quality CD-R media to store jobs and make Configuration Back-ups.

‘Bargain’ CD-R media can be problematic and adversely affect the ability to store

and retrieve information. This also applies to CD-RW media.

CD-RW media Use of CD-RW media can cause read problems when written on one drive and read

from another.

DVD/CD RW The DVD/CD RW drive only supports writing to CD. The drive does not support

writing to DVD.