User's Manual

Tab behaviors
for Non-MFF
systems only
On Non-MFF systems, tab jobs are delivered to the finisher face down in 1 to
N order. As such, the following must be noted:
• Tabs need to be loaded in the feeder tray in 1 to N order (commonly referred
to as forward ordered tabs)
• There are no special loading instructions required for drilled or pre-printed
stock, load those stocks according to the labels on the feeder trays. (Note: if
the labels indicate that drilled paper is to be loaded with the holes along the
trailing edge (to the right), then the incorrect labels are installed on the feeder
module. Contact service for a replacement.)
Additional information for running tab jobs appears in the Operating Feature Hints &
Tips section of this document.
General System Hints & Tips
Subtopic CQ # Description and Recommended Action
A new jam clearance
procedure
An unclearable jam situation may occur that requires service
intervention. To minimize this occurrence, for any jam condition, the
operator should clear the offending jam and then check and clear
area 6 of the print engine – before closing door for cycle up.
Customer diagnostics Entering and exiting customer diagnostics very quickly may cause
the system to be stuck in diagnostic mode. As a workaround, enter
and then exit diagnostics to clear this condition.
Customer diagnostics 22707 If a customer diagnostic routine is currently running (e.g.. image
quality setup), do not interrupt that routine and shut the machine
down until it completes. Also, do not select “No” upon exiting. The
system may be stuck in a diagnostic mode upon restarting and no
additional customer jobs can be run until service gets the machine
out of that diagnostics mode.
DocuSP Remote
Workflow
DocuSP Remote Workflow 5.1 software supports version 4.1, 4.2,
5.0, and 5.1. If an earlier version of DocuSP is being used, you can
install an older version of DocuSP Remote Workflow.
DocuSP Remote
Workflow
DocuSP Remote Workflow 5.0 software supports version 4.1, 4.2
and 5.0. The implication is that the Xerox software supports the
current release and two past major releases. 3.8 will no longer be
visible to the 50 DRW software. An alternative is to run two
applications on the desktop.
Engineering data push 13045 While doing an Engineering data push, system resources are used
extensively during the DocuSP Customer Outload portion of the
collecting and transmitting states. The system is able to continue
running, however, sometimes the UI appears to slow down or not
update while printing jobs for up to several minutes. This will correct
itself after resources are freed up.
Envelopes 21743 Conflicts for envelope jobs with finishing selected are not defined nor
implemented.
Fault 01-4135 A 01-4135 fault (indicating loss of power to the LVPS) may occur
after a system restart. This is normal if a power outage has occurred,
or if the white power button was used to cut power to the machine. In
some cases this fault may be incorrectly declared after a normal
shutdown. If the machine is operating normally, please clear this fault
and continue.
7