User's Manual

INTEGRATION INFORMATION FOR THE OEM
The module is subject to the following FCC rule parts: 15.207, 15.209, 15.247
FCC Label: The FCC ID is on the front of the device. It is easily visible.
The device FCC ID is 2ATBKDSMPSDR.
A label with the following statements must be attached to the host end-product:
This device contains FCC ID: 2ATBKDSMPSDR.
Or “Contains transmitter module FCC ID: 2ATBKDSMPSDR “
The manual provides guidance to the host manufacturer will be included in the documentation that will
be provided to the OEM.
The module is limited to installation in mobile or fixed applications.
The separate approval is required for all other operating configurations, including portable
configurations and different antenna configurations.
The OEM integrators are responsible for ensuring that the end-user has no manual or instructions to
remove or install module.
The module is limited to OEM installation ONLY.
Module grantee (the party responsible for the module grant) shall provide guidance to the host
manufacturer for ensuring compliance with the Part 15 Subpart B requirements.
The host manufacturer is responsible for additional testing to verify compliance as a composite system.
When testing the host device for compliance with the Part 15 Subpart B requirements, the host
manufacturer is required to show compliance with the Part 15 Subpart B while the transmitter
module(s) are installed and operating. The modules should be transmitting and the evaluation should
confirm that the module’s intentional emissions are compliant (i.e. fundamental and out of band
emissions) with the Radio essential requirements. The host manufacturer must verify that there are no
additional unintentional emissions other than what is permitted in the Part 15 Subpart B or emissions
are complaint with the Radio aspects.