User Manual

SUPERPRO
®
7000 User’s Guide Chapter 3
o Address Change indicates whether a different start and end address
shall be applied for the programming zone of the device.
 To set the order of the batch processing functions, select Edit Auto from the
Options menu. The system displays the Edit Auto screen.
 For devices that include the configuration word, you must set the
configuration word before programming to ensure that the chip can be used
on the target system. The configuration words for some devices are contained
in the data file. Therefore, the system automatically loads the configuration
word into the configuration word buffer when loading the data file. For some
devices, you must manually make the selection. Select Device Configuration
Word from the Device menu to open the ConfigWord screen.
 Many devices must meet some special requirements for the programming of
a chip, including special algorithms conventions. Read the device manual or
instructions carefully and adjust the operation steps or buffer data as needed.
If an adapter is required for programming, the system displays information
about the adapter in the device information screen.
3.2.4 Execute programming
Insert the chip properly into the socket. If the prompt information indicates a need
for an adaptor, you may purchase the adapter. The operation procedure for the
programming of a chip is described as the following steps:
 Blank Check
NOTE: You can skip this step if the chip is brand new.
The Blank Check fails on electrically erasable chips containing some
information. In this case, perform the Erase operation first. You do not
need to erase EPROM chips for which the data can be overwritten.
 Program
18 of 51