User Manual

SuperPro
®
6104GP User’s Guide 42
4. Indicate the mode for verifying the data by selecting one of the Verify Mode options.
These options refer to the voltage of the pin VCC, which may vary when the programmer
verifies the data. The manufacturer provides the MinVcc and MaxVcc values for verifying
the data.
VCC(+/- 5%) or VCC(+/- 10%) is adopted for the verification. If VCC = 5.00V, select one of
the following options:
 VCC = 5.00V and verify the data once
 VCC = 4.75V and VCC = 5.25V, and verify the data twice (+/- 5%)
 VCC = 4.50V and VCC=5.50V, and verify the data twice (+/- 10%)
Buffer
The Buffer view of the Operation Option screen is illustrated below.
The default programming method is to program the device from the start address to the end
address. However, you may choose to program only a part of the chip, such as with most
E/EPROM (FLASH) devices.
Note: Most single-chip microcomputers do not allow a change to the start address of the
device.
1. For each file, enter the Start Address.
2. For each file, enter the End Address.