User's Guide

Xeleum Xi-Fi Wireless Control Application User Guide Page | 11
You will see a comet animation spinning after the Sync circle is clicked. This indicates that
the Application is communicating with the actual fixtures, changing settings, and receiving
confirmations. The comet will disappear when complete. Time to completion is dependent
on the number of operations in the queue to perform and the network size.
Note: Changes to settings do not affect fixtures in real time. The settings will need to be
synchronized to the Xi-Fi network before changes can be seen in the fixtures.
Adjust Zone Settings
Located on the right side of the screen, the settings panel contains setting controls that will
allow you to change the following parameters for all fixture that belong to the group…
Brightness
(a.k.a. High-End Trim, or Occupied Brightness) - A slider adjusts the brightness ‘Level’ that
the fixture will output when group occupancy is detected or when ‘Occupancy Sensing’ is
disabled. This adjustable ‘Level’ is expressed as a percentage of the fixture’s maximum
brightness output.
TIP: It is recommended that this brightness level be set to a higher level than the unoccupied brightness level.
Occupancy Sensing
(a.k.a. Motion Sensing) – This feature is controlled by the occupancy, or motion, sensor
that is integrated into the Xi-Fi enabled device. Occupancy sensing can be enabled or
disabled by clicking the power symbol ( ) next to the title of its subsection. Adjustable
occupancy parameters include:
• Unoccupied Level – sets the brightness level of the grouped fixtures as a
percentage of the fixture’s maximum brightness output when no occupancy is
detected
• Motion Timeout – sets the amount of time starting from the moment no
occupancy is detected for the grouped fixtures to dim down to the Unoccupied
Level.
Daylighting
(a.k.a. Ambient Daylight Sensing) – This feature is controlled by the ambient light sensor
that is integrated into select Xi-Fi enabled devices [see Xeleum product brochure…]. Daylight
sensing can be enabled or disabled by clicking the power symbol ( ) next to the title of
its subsection. Response to ambient light levels is based on the individual fixture’s
reading, not the whole group, which is unlike the ‘Occupancy Sensing’ operation.
However, the group of fixtures will share the same parameters set by the Xi-Fi App.
Adjustable occupancy parameters include: