User's Manual

RETURN TO HOME BUTTON PROCEDURE

1. Make sure GPS Signal is showing at least ‘Good’ (if not,

visually track the aircraft as it ies back to home position).

2. Press and hold the Return to Home button for 3

seconds.

3. The aircraft will ascend to a pre-set altitude, or if at a

greater altitude than the programmed altitude it will

remain at that altitude, and then return to the Home Point

in shortest path (straight line).

4. The Smart Pilot System indicates the aircraft is under

Return to Home Mode.

5. When reaching the home point, the aircraft will hover

for few seconds then proceed to auto land (during the

descent the operator can reposition the aircraft to clear

away from obstacles or land in preferred spot).

LANDING AND RETURN TO HOME CANCELLATION

When Landing and Return to Home is in process, the user may stop the Return to Home process by tapping on the cancel

button located on the right OR press and hold the Auto Takeoff/Landing and RTH hard key until the process is cancelled.