User's Manual

54
AUTO TAKE OFF PROCEDURE
1. Short Press and Long Press the Auto Take Off button
for 3 seconds.
2. Take off dialog will pop up on the screen. Release the
button to cancel action anytime.
3. The aircraft will arm itself and take off.
4. The aircraft will rise to 4 to 5 ft. ( If the aircraft is in
POSITION mode it will hold position until the operator
takes over, but if it is in ALTITUDE mode the operators
needs to correct the altitude to prevent drifting.)
DISARMING THE AIRCRAFT
After landing the aircraft, hold the throttle stick down and to the left to disarm the motors. The LED indicators will change
color followed by a long beep and propellers will stop spinning. Make sure all the LED indicators are solidly lit by the same
color (either Green or Blue) with no blinking before moving the sticks back to central position. If the LEDs are blinking the
aircraft is still in arming mode, keep the sticks in the same position until all the LEDs are solid (either Green or Blue)
(Left) (Right)
Push the both control sticks down and to the right and
wait for the LED’s light change. Move the throttle stick to
the middle position and the aircraft is ready to take off
manually.
When disarming, the LEDs will blink rapidly with different
colors followed by a long beep, the motors will then
engage, and the propellers will start spinning.
Ensure the aircraft is fully disarmed (either solid Green or Blue LED) before returning the left thumb stick to the
middle position.
Follow the previous pre-ight check, as stated in arming the aircraft above.
AUTO TAKE OFF AND LANDING
For ease of operation and to assist beginner operators, the EVOLVE 2 aircraft can take off and land automatically.