User's Manual

37EVOLVE 2 User Manual V1.2 by XDynamics Limited
PAIRING THE GROUND STATION AND AIRCRAFT
The EVOLVE 2 aircraft and its Ground Station should be paired out of the box per factory settings. In the event you need
to repair the aircraft and the Ground Station, please follow the steps below:
ANTENNAS (INTERNAL/EXTERNAL)
You can y with the built-in antennas or mount external antennas for extra range or stronger signal. To enable external
antennas on the User Interface, please use the following path: DRONE SETTINGS > GROUND STATION > ANTENNAS OR
DRONE > START HERE > CHECKLIST > ANTENNAS (Bottom of the list)
IMAGE TRANSMISSION
In wide open areas with no electromagnetic interference, the EVOLVE 2 can smoothly transmit video signal up to 1080p
resolution. EVOLVE 2 operates on the 2.4 GHz band, automatically selecting the best transmission channel. You can access
more information under the following path: DONE SETTINGS > GROUND STATION > IMAGE TRANSMISSION
Always make sure that your external antennas are securely mounted to the ground station before switching to
externals. Switching to EXTERNAL antennas without securely mounting external antennas may result damage to the
ground station when using incorrectly
If you encounter short distance range issues (1 km), tap the ‘Run Diagnostics’ button to check the health of your
built-in antennas.
PAIRING PROCEDURES
1. Navigate to the Pairing Page under the following path:
DRONE SETTINGS > GROUND STATION > PAIRING
2. Turn on the aircraft.
3. Keep the aircraft at least 3 ft away from the Ground
Station.
4. Tap “Start Pairing” on the Ground Station screen.
5. Follow the on-screen instructions until the pairing is
complete.
Only required if pilot is trying to pair a new aircraft to the Ground Station or a new Ground Station to the aircraft.