Instructions / Assembly

DO NOT RETURN TO RETAILER YOU PURCHASED AT.

CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or service@xdp-recreation.com

STEP 10 - Standing N Swing Assembly

 Insert G3 (which is pre-assembled with G1, G2 and G4) through the hole on A1 and A2.Secure

using G7 and G8 as shown in the diagram below.

 Insert G5 to the G6 through G7 and secure with G9 and G10 as shown in the diagram below.

NOTE:

1. Do not over-tighten the nuts and bolts at every step.

2. Do not snap in the cover of plastic cap until you have finished the assembly of

each step and went back to tighten all of the nuts and bolts.

G10