User Manual

light

blade

heavy

blade

Propellers

Always balance all propellers used on your X PlusOne. Balanced propellers will greatly improve performance and allow

clearer images from onboard cameras. To balance propellers, follow the recommended procedures below.

1. Insert a rod into the hole in the center of the propeller

TIP: For best results use a propeller balancer.

2. Allow propeller to freely rotate and make note of which blade points up, this is the “light” blade

Add weight to the light blade. This can be done by adding a small piece of tape or nail polish to the underside of the

propeller blade.

Repeat steps 2 and 3 until the propeller balances horizontally on the rod

Non-Serviceable Components

There are several components of the X PlusOne that are not individually replaceable. These parts can be found in the

wing assembly (main wing foam, wing spars, battery compartment, and spar insert) and the pylon assembly (main pylon

foam, and pylon spars).

To replace these components:

• If the component to be replaced is in the wing, remove both pylons and set them aside

• If the component is in a pylon, remove that pylon and set the other pylon and wing aside

• Remove the cover (either wing cover or pylon cover) by removing the screws holding it in place and sliding the

cover off

• TIP: You may want to take several pictures after removing the cover to aid in reassembly.

• Remove all electronics from damaged assembly

• Make careful note of all connections to the removed components as well as wire routing throughout the assembly

• Unscrew motor mount(s) from spars and foam and remove motor mount(s)

• Install motor mount into new wing or pylon assembly

• Install electronics into new wing or pylon assembly

• Check that all connections and wire routes are installed properly

• Reinstall the cover

• Reinstall the pylon(s)

Serviceable Components

• If the component to be replace is in the wing, remove both pylons and set them aside If the component is in a

pylon, remove that pylon and set the other pylon and wing aside

• Remove the cover (either wing cover or pylon cover) by removing the screws holding it in place and sliding the

cover off

• TIP: You may want to take several pictures after removing the cover to aid in reassembly.

• If the cover is damaged, simply replace it and reassemble your X PlusOne

Replace damaged component

• For electrical components, make careful note of all connections to that component as well as wire routing and

make sure to reconnect all connections and run all wires as they were before

• For motors or motor mounts, remove the screws holding the motor mount to the spars and the screws holding the

mount to the wing or pylon foam

• Reinstall the motor mount and reconnect the motor wires to the speed control (making sure to reconnect the wires

as they were before)

• Reinstall the cover

• Reinstall the pylon(s)