User Manual

16
Gimbal Board Programmer
Every gimbal comes with a programming cable. This cable would be used to reinstall or update the gimbal board. The
software will be provided as needed if the gimbal is malfunctioning.
Fixed Mount
Your X PlusOne will come with a fixed mount to allow you to mount a GoPro camera to your craft. Mount the fixed mount
and GoPro the same as the gimbal above. See below for final set up:
FPV (First Person View)
First-Person-View accessories allow the pilot to stream live footage from the craft to the ground.
FPV Power
Your X PlusOne has a switch to power on the FPV in your craft. You will have to power on the FPV in order to transmit a
live feed.
*Check local regulations for use of 5.8 GHz, 200mW FPV transmitter.
The switch is set in the “Off” position and is labeled. Simply switch to “On” before using FPV accessories.
Cable
An FPV Cable is included in your package and allows you to connect your GoPro to your craft to transmit a live feed.
Connect the Micro USB end to the GoPro and the other connector to the matching wire labeled “FPV” in your craft.
FPV Switch