User Manual

• DO NOT attach the batteries to wall outlets or car charger sockets directly, and always use an xCraft approved

adapter. xCraft takes no responsibility if the battery is charged using a non-xCraft charger.

• Never leave the battery unattended during charging. DO NOT charge the battery near flammable materials or on

flammable surfaces such as carpet or wood.

• DO NOT charge battery immediately after flight, because the battery temperature may be too high. DO NOT

charge the battery until in cools down to near room temperature. Charging the battery outside of the temperature

range of 32° F to 104 ° F may lead to leakage, overheating, or battery damage.

• Disconnect the charger when not in use. Examine the charger regularly for damage to the cord, plug, enclosure,

or other parts. DO NOT clean the charger with denatured alcohol or other flammable solvents. Never use a

damaged charger.

Battery Storage

• Keep batteries out of the reach of children and pets.

• DO NOT leave the battery near hear sources such as a furnace or heater. DO NOT leave the batteries inside of a

vehicle on hot days. The ideal storage temperature is 64° F to 82° F.

• Keep the battery dry. Never drop the battery into water.

• DO NOT drop, strike, impale, or manually short-circuit the battery.

• Keep the battery away from metal objects such as glasses, watches, jewelry, and hairpins.

• Never transport a damaged battery or a battery with power level higher than 50%.

For long term storage, store the battery in a 64° F to 82° F environment, between 45-85% relative humidity and with 50%

charge. Always make sure to store the battery in a place where it won’t be exposed to extreme temperatures or direct

sunlight.

6. Accessories

Gimbal

The X PlusOne 2-axis, carbon fiber gimbal can be added on to capture smooth video footage from a GoPro camera.

a)Remove the nosecone from your X PlusOne and place the gimbal in its place. If you are facing the battery

compartment on the craft, the vertical gimbal motor should be on your left (see image).

b) Plug the gimbal board into the power cord before mounting gimbal. That way the connection will be held between the

gimbal and the battery, as shown.

c) Insert the long screws included in hardware kit, through the holes in the battery compartment and the gimbal. Secure

with included nut on the backside. The direction of the screws is irrelevant.

d) Attach GoPro to gimbal base using included bolt, spacer and wing nut. Position the GoPro so that it balances freely

level; facing forward

Front

Back

Power Cord