Quick start Guide

2. Prepping the Craft
1. Pylons
a) Connect the two bullet connectors, and one ESC wire together from the pylon to the wing.
*Ensure that colors align correctly i.e. red to red, black to black, and silver edge to silver edge on the connector.
b) Insert the pylon spars into the connector on the wing and slide the pylon onto the wing. Bundle the wires into the
cavities in the wing and pylon.
*if there is resistance, “hug” the pylon to the craft by placing the motor mount in the pit of your arm and squeezing the pylon into place
with your hand.
c) Install the second pylon onto the wing by repeating steps a-b.
2. Nosecone
a) Install as shown below using the supplied hardware.
*for fixed mount or gimbal mounting instructions, see manual.
12 mm screw
20 mm screw
+ washer
40mm screws
3mm nuts
ESC wires