Installation Guide

DOOR SWEEP INSTALLATION INSTRUCTIONS
Use with Standard (XCL-111), Low-Prole(XCL-121),
and Versa-Line(XCL-131,141,151)
COMPONENTSCAUTION!TOOLS
WEAR SAFETY GLASSES + WORK GLOVES!
U.S. PATENT NO. 9,867,367
SWEEP*
END-CAP
SCREWS**
MOUNTING
SCREWS**
END-CAPS
BG0423
TAPE MEASURE SQUAREPENCIL
HEAVY-DUTY
SHEARS
HACKSAW or
CUT-OFF TOOL
DRILL
MEASURE BETWEEN DOOR STOPS, SUBTRACT 1/8”
MEASURE BETWEEN DOOR JAMBS
1. MEASURE DISTANCE BETWEEN JAMBS FOR “OUT-SWINGING” DOORS (S1). MEASURE THE DISTANCE BETWEEN
DOOR STOPS FOR “IN-SWINGING” DOORS (S2). SWEEP IS INTENDED TO MOUNT ON EXTERIOR OF BUILDING.
SUBTRACT 1/8” FOR “IN-SWING” DOORS TO ACCOUNT FOR END-CAPS.
S1 - “OUT-SWING” DOOR
S2 - “IN-SWING” DOOR
1/4”
#
2
#
1
#2 PHILLIPS or
1/4” HEX BIT
#1 PHILLIPS
BIT
2. MARK THIS DIMENSION ON YOUR SWEEP AND COVER, IF APPLICABLE(S3). USE WOODWORKING SQUARE, OR
SIMILAR TOOL TO DRAW LINE (S4).
3. CAREFULLY CUT ALUMINUM RETAINER USING HACK SAW OR CUT-OFF WHEEL (S5). STOP CUTTING AFTER
RETAINER SEPARATES. CUT STRAIGHT TO ENSURE END-CAPS SIT FLUSH. NOTE: WHEN CUTTING ALUMINUM
RETAINER IT IS OKAY TO CUT THE TOP OF THE SEAL SLIGHTLY.
* Sweep shown for reference. Sweep style varies depending on product. ** Extra screws included.
OPTIONAL SWEEP COVER (AVAILABLE W/ VERSA-LINE SWEEPS)
4. CUT SEAL COMPLETELY USING HEAVY DUTY SHEARS (S6). CUTTING
THIS STRAIGHT AND AS CLOSE TO RETAINER AS POSSIBLE WILL
ALLOW END-CAPS TO SIT FLUSH. HOLD THE RUBBER TIGHTLY WHILE
CUTTING TO PREVENT RUBBER FROM SHEARING, RESULTING IN
ANGLED CUT. IF YOU CAN, MARK RETAINER EDGE LOCATION ON
RUBBER, THEN SLIGHTLY PULL RUBBER OUT OF SWEEP & CUT AT
MARK. SLIDE BACK INTO PLACE. CLEAN UP ALUMINUM EDGE WITH
DE-BURRING TOOL, BLADE, AND/OR METAL FILE, IF NEEDED.
S3 S4 S5
S6